Psequel m1 how to#

Example: Let's say you wanted to move this combination of logic gates down.įirst, highlight the components that you want to move. Instead of moving them one by one, try highlighting them all to make life easier. Sometimes, you might want to move multiple components at once. Tip #8: Moving multiple components at once After adding an input, you can double click on it to add a label.ĭouble clicking also works with outputs, logic gates, registers, subcircuits etc. Note: Make sure you are in the 'Edit selection and add wires' mode (just click on the black arrow at the top left of the window). Having names for your inputs and outputs are important to keep your circuit readable and organized. Tip #7: Adding names to your input and output by double clicking When you do command (control) K, you can also change the tick frequency under the simulate tab (right under 'Ticks Enabled'). Press command (control) K to tick repeatedly. There are mainly two ways to tick the clock. Try playing around with these appearances to choose the appearance that fits your circuit the best.Ģ) Click on the splitter that you want to change the appearance of.ģ) In the properties section of the splitter (at the bottom left section of your window), edit the 'Facing' and the 'Appearance' as you wish. The appearance attribute (Left-Handed, Right-Handed, Centered, or Legacy) to change how the splitter looks. Tip #5: Changing the appeareance of splitters This tip will be particularly useful when you have a big splitter (like for splitters that have 32 fan outs.) Right click on a splitter and choose distribute ascending/descending to change distrubtion. Sometimes, you would want to reverse the distribution of splitters. Tip #4: Reversing the distribution of splitters To change the appearances, follow the following steps:Ģ) Click on the gate that you want to change the appearance of.ģ) In the properties section of the gate (at the bottom left section of your window), edit the 'Facing' and the 'Appearance' as you wish. Note: You can also edit the 'Data Bits' attribute to change the number of bits each input will have (above examples have 1-bit inputs). The number of inputs to change the appearance (and the functionality) of the gate. You can change the facing attribute (North, South, East, or West) and Tip #3: Changing the appeareance of logic gates If you don't want to add the circles, you don't have to. To add the circles, follow the following steps:ġ) Make sure you are in the 'Edit selection and add wires' mode (just click on the black arrow at the top left of the window).Ģ) Click on the gate that you want to add the circle to.ģ) In the properties section of the gate (at the bottom left section of your window), choose which input to negate. Note that you can add these circles for any type of logic gate. Instead of adding a not gate, you can add little circles to negate an input. Tip #2: Negating an input to a gateĪdding circles instead of not gates can make your circuit neater. You can also do this to connect splitters and splitters.Īlternatively, if you do now want to have wires between your splitter and the gate, you can just connect them and not drag the gate. This trick becomes very useful when you have a lot of inputs (like 32 inputs). Some students connect wires from splitters to gates one by one, which becomes tedious when the number of inputs gets large. Tip #1: Connecting splitters to gates (and splitters to splitters)

Psequel m1 how to#

CS 3410 Logisim Tips: How to make life easier